An application uses broadcast traffic to send data to IPv4 hosts. How can the application
communicate using IPv6?
A.
Anycast
B.
Unicast
C.
Broadcast
D.
Multicast
How can the application communicate using IPv6?
An application uses broadcast traffic to send data to IPv4 hosts. How can the application
communicate using IPv6?
I think it is Multicast
For broadcast traffic, IPv4 uses broadcast packets vs IPv6 uses Unicast packets
With IPv6 the broadcast addresses are not used anymore, because they are replaced with multicast addressing
In IPv6, there’s no longer any broadcast – sending one packet to a large number of unspecified hosts. There’s only multicast, unicast and anycast. In IPv6 all nodes are required to support multicast. Without multicast, many services that you need will simply not work. A packet sent to a multicast address is delivered to all interfaces identified by that address.
http://ipv6friday.org/blog/2011/12/ipv6-multicast/
I guess the correct answer is (D)
New 200-310 Exam Questions and Answers Updated Recently (14/Apr/2017):
NEW QUESTION 296
Which cisco technology can connect more than two switches so that they behave as one switch?
A. Etherchannel
B. Trunking
C. VSS
D. Stackwise
Answer: D
NEW QUESTION 297
Which two processes are included in the Build phase of the Cisco Design Life Cycle? (Choose two.)
A. Design
B. Validation
C. Analysis
D. Deployment
E. Assessment
Answer: BD
NEW QUESTION 298
Which statement about modular network design is true?
A. It is complex and should be used only in specialized situations
B. Each deployed module is identical to the others,simplifiying configuration
C. It is flexible architecture that simplify design,management and troubleshooting
D. Each module include access,distribution and core layers
Answer: C
NEW QUESTION 299
When designing changes to an existing network, which two options are documented to understand environmental constraint? (Choose two.)
A. Utilization of network resources
B. Floor and rack space availability
C. Host naming conventions
D. Heating and Air conditioning
E. Location of existing documentation
Answer: BD
NEW QUESTION 300
In the traditional hierarchical LAN design,Which two statement about the distribution layer are true? (Choose two.)
A. It typically is connected directly to the internet It provides users direct access to the network
B. It uses Layer 2 switching only
C. It aggregates data from the access layer
D. Policy is implemented at this layer
Answer: D
NEW QUESTION 301
Which level needed to be set on Cisco WLC for VolP traffic?
A. PLATINUM
B. GOLD
C. SILVER
D. BRONZE
Answer: A
NEW QUESTION 302
Choose considerations for access layer design? (Choose two.)
A. QOS
B. Routing
C. Port security
D. Load balance
E. HSRP
Answer: AC
NEW QUESTION 303
For a VLAN that requires 60 hosts, which subnet is the most efficient?
A. 10.0.0.1/20
B. 172.31.17.0/27
C. 10.10.10.0/26
D. 192.168.15.0/24
Answer: C
NEW QUESTION 304
Which option is an advantage of a Layer 3 access model over the traditional Layer 2 access model?
A. Increased neighbor adjacencies
B. Faster convergence
C. Reduced resources on the router
D. Reduced size of routing table
Answer: B
NEW QUESTION 305
……
P.S. These New 200-310 Exam Questions Were Just Updated From The Real 200-310 Exam, You Can Get The Newest 200-310 Dumps In PDF And VCE From — http://www.passleader.com/200-310.html (326q VCE and PDF)
Good Luck!
Besides, part of that new 326Q 200-310 dumps are available here:
http://www.ciscobraindump.com/?s=200-310
Best Regards!