From where can you enable NAT?
A.
Routing and Remote Access ==> IPv4 ==> Create new Routing Protocol
B.
Missing
C.
Missing
D.
Missing
where can you enable NAT?
From where can you enable NAT?
Leave a Reply
From where can you enable NAT?
From where can you enable NAT?
A.
Routing and Remote Access ==> IPv4 ==> Create new Routing Protocol
B.
Missing
C.
Missing
D.
Missing
this one was tough!
Clearly, the answer is C.
Actually D. RRAS is not installed on this server, therefore its missing.
https://www.google.com/search?biw=1536&bih=760&tbm=isch&sa=1&q=routing+and+remote+access+server+setup+wizard+2012&oq=routing+and+remote+access+server+setup+wizard+2012&gs_l=psy-ab.3…22204.29123.0.29217.50.27.0.0.0.0.467.4075.2-1j6j4.11.0….0…1.1.64.psy-ab..39.11.4073…0j0i67k1j0i24k1.oWI8c2bgky8#imgrc=4COPxDMwbzUy4M:
Sorry I’m dumb, i meant D.
Correct Answer is Z: Routing and Remote Access Console\IPv4\General.
The alternate answer is U: Select NAT, and add Interfaces.