Observing the output below from the PE router, select what path EoMPLS will take before exiting a router: PE#show mpls l2transport vc 100 detail Local interface: Fa0/0.1 up, line protocol up, Eth VLAN 100 up Destination address: 172.0.0.3, VC ID: 100, VC status: up Preferred path:
Tunnel1, active Default path: disabled Tunnel label: 3, next hop point2point Output interface: Tu1, imposed label stack {27 20} Create time: 00:07:11, last status change time: 00:07:11 Signaling protocol:
LDP, peer 172.0.0.3:0 up MPLS VC labels: local 16, remote 20 Group ID: local 0, remote 0 MTU: local 1500, remote 1500 Remote interface description: Sequencing: receive disabled, send disabled
A.
172.0.0.3
B.
FastEthernet 0/0
C.
FastEthernet 0/0.1
D.
Tunnel1
E.
This is an invalid output