what path EoMPLS will take before exiting a router:

Observing the output below from the PE router, select what path EoMPLS will take before exiting a router:

PE#show mpls l2transport vc 100 detail
Local interface: Fa0/0.1 up, line protocol up, Eth VLAN 100 up Destination address: 172.0.0.3, VC ID: 100, VC status: up
Preferred path: Tunnel1, active
Default path: disabled
Tunnel label: 3, next hop point2point
Output interface: Tu1, imposed label stack {27 20}
Create time: 00:07:11, last status
change time: 00:07:11
Signaling protocol: LDP, peer 172.0.0.3:0 up
MPLS VC labels: local 16, remote 20
Group ID: local 0, remote 0
MTU: local 1500, remote 1500
Remote interface description:
Sequencing: receive disabled, send disabled

Observing the output below from the PE router, select what path EoMPLS will take before exiting a router:

PE#show mpls l2transport vc 100 detail
Local interface: Fa0/0.1 up, line protocol up, Eth VLAN 100 up Destination address: 172.0.0.3, VC ID: 100, VC status: up
Preferred path: Tunnel1, active
Default path: disabled
Tunnel label: 3, next hop point2point
Output interface: Tu1, imposed label stack {27 20}
Create time: 00:07:11, last status
change time: 00:07:11
Signaling protocol: LDP, peer 172.0.0.3:0 up
MPLS VC labels: local 16, remote 20
Group ID: local 0, remote 0
MTU: local 1500, remote 1500
Remote interface description:
Sequencing: receive disabled, send disabled

A.
172.0.0.3

B.
FastEthernet 0/0

C.
FastEthernet 0/0.1

D.
Tunnel1

E.
This is an invalid output



Leave a Reply 0

Your email address will not be published. Required fields are marked *