Which command is needed to change the next-hop address when ASBR2 is not configured?

Refer to the exhibit.

The exhibit illutrates the exchange of VPN route and label information
between MPLS VPN inter-AS. The exhibit also shows ASBRS exchanging VPN-IPv4 addressed.
Which command is needed to change the next-hop address when ASBR2 is not configured?

A.
Redistribute command with the BGP routing process

B.
Redistribute command with connected

C.
Redistribute command with the IGP routing process

D.
Redistribute command with static

Explanation:
Figure 11-3 illustrates the exchange of VPN route and label information between autonomous
systems. The only difference is that ASBR2 is configured with the redistribute connected
command, which propagates the host routes to all PEs. The redistribute connectedcommand is
necessary because ASBR2 is not the configured to change the next hop address.
Figure 11-3 Host Routes Propagated to All PEs Between Two Autonomous Systems

Reference:
http://www.cisco.com/en/US/docs/net_mgmt/ip_solution_center/4.0/mpls/user/guide/11_isc.html