Which spanning-tree mode uses the name command to configure a region name?
A.
MST
B.
PVST+
C.
PVRST+
D.
RSTP
Which spanning-tree mode uses the name command to configure a region name?
Which spanning-tree mode uses the name command to configure a region name?
MST
Correct Answer: A
Dumps4Download.co.in is providing Free Cisco 640-878 dumps. It is giving you 100% valid 640-878 dumps. Dumps4Download is providing 640-878 exam dumps in PDF and online test engine formats. Dumps4Download.co.in this is the best source for exam study material where you can get free CCNA, CCNA, CCDA, CCPD, CCVP, CCIP and all certifications Exam all questions from Cisco exam Get a great discount.
They provide you Cisco certifications exam system which helps you to prepare your exam in short time, the dumps they provide are 100% actual and verified visit this site and prepare your exam. Visit us for more information our customer care and live chat support on 24/7. For More Detail: https://www.dumps4download.co.in/free-640-878-practice-questions.html
Passed 640-878 Exam Yesterday! Studied 2017 Latest 133Q&As PDF and VCE Dumps: https://www.braindump2go.com/640-878.html , this file covers all new questions and updated in step with the official test center. Still got some new questions and share here:
QUESTION
Which three are examples of a link-state routing protocols and static routing? (Choose three.)
A. EIGRP
B. RIP
C. OSPF
D. IS-IS
E. IP default-gateway
F. ODR
G. Proxy Arp
Answer: CDE
QUESTION
What are two legitimate IPv4 to IPv6 migration technologies? (Choose two.)
A. Lift and shift
B. Dual stack backbones
C. In IPv4 / Out IPv6
D. IPv6 over IPv4 tunneling
E. IPv6 phasing
Answer: BD
QUESTION
A customer has installed a second router and copied the configuration from the first router, as
shown below. What change is needed to ensure that router 1 is the primary IP address?
Router 1
standby 1 priority 110
standby 1 preempt
Router 2
standby 1 priority 120
standby 1 preempt
A. decrease the priority on router 2 to 109
B. decrease the priority on router 1 to 109
C. remove standby 1 preempt from router 1
D. increase the priority on router 2 to 130
E. increase the priority on router 1 to 119
Answer: A
QUESTION
Which configuration error within an AS can cause a Cisco IOS XR router to not announce certain
prefixes to its EBGP peers?
A. Some prefixes were mistagged with the no-export BGP community.
B. Some prefixes were set with a MED of 0.
C. The outbound BGP route policy has only set actions that are defined without any pass actions
that are defined.
D. The inbound BGP route policy has only set actions that are defined without any pass actions
that are defined.
Answer: A
QUESTION
Refer to the configuration snippet below. A network engineer has been tasked with implementing
a security policy that prevents subnet 209.165.202.128/27 from accessing web server
209.165.200.224. All users are now unable to access the web server. What command is missing
from the access list configuration?
Configuration:
switch(config)#access-list 1 deny 209.165.202.128 0.0.0.31
209.165.200.224
switch(config)#interface FastEthernet 0/0
switch(config-if)# ip access-group 1 in
A. switch(config-if)#ip access-group 1 out
B. switch(config)#ip access-list 2 permit any any
C. switch#ip access-list 2 permit any any
D. switch(config)#ip access-list 1 permit any any
Answer: D
QUESTION 8
Drag and Drop Question
Drag and Drop the IS-IS router type on the left to its correct description on the right.
Answer:
QUESTION
Which procedure is used as the last resort disaster recovery procedure to completely replace the
currently installed IOS XR software on Cisco IOS XR routers?
A. netboot
B. turboboot
C. install recovery
D. install rollback
E. install add and install activate
Answer: B
QUESTION
Which three Cisco platforms are classified as core routers? (Choose three.)
A. Cisco XR 12000
B. Cisco ME 3400
C. Cisco ASR 1006
D. Cisco CRS-3
E. Cisco ASR 9010
F. Cisco 3900
Answer: ADE
QUESTION
Which statement about Cisco IOS XE software is true?
A. It uses a two-stage configuration process.
B. It is identical in look and feel to Cisco IOS software.
C. It runs on the Cisco ASR 9010 platform.
D. Packages can be added using the install add and install activate commands.
E. It runs on the Cisco ME 3400 platform.
Answer: B