which three settings should be configured during the initial setup of a Cisco 9000 Series switch using SAN-OS Release 2.0?

In order to allow access to a switch using Telnet, which three settings should be configured during the initial setup of a Cisco 9000 Series switch using SAN-OS Release 2.0? (Choose three.)

In order to allow access to a switch using Telnet, which three settings should be configured during the initial setup of a Cisco 9000 Series switch using SAN-OS Release 2.0? (Choose three.)

A.
assign an admin password

B.
accept auto for the switchport trunk mode

C.
configure the IP address for the VSAN 1 interface

D.
configure the netmask for the IP address

E.
configure the IP address for the Mgmt0 interface

F.
Configure SSH with an RSA1 key



Leave a Reply 0

Your email address will not be published. Required fields are marked *