Choose the answer that properly completes the command list.

Exhibit

An H.323 gateway is being configured to support CallManager redundancy. Dial-peer 102 should point to the connection to the primary CallManager. There are two commands missing, represented by a set of questions marks (???????). Each answer below has two parts. The first part would replace the first question marks, and the second part would replace the second questions marks. Choose the answer that properly completes the command list.

Exhibit

An H.323 gateway is being configured to support CallManager redundancy. Dial-peer 102 should point to the connection to the primary CallManager. There are two commands missing, represented by a set of questions marks (???????). Each answer below has two parts. The first part would replace the first question marks, and the second part would replace the second questions marks. Choose the answer that properly completes the command list.

A.
preference 0, preference 10

B.
preference 10, preference 0

C.
priority 0, priority 5

D.
priority 5, priority 0

E.
primary, secondary

F.
secondary, primary

Explanation:
preference(dial-peer)
To indicate the preferred order of a dial peer within a hunt group, use the preference command in dial-peer configuration mode. To remove the preference, use the no form of this command.
preference value
no preference
Syntax Description

value Integer from 0 to 10, where the

lower the number, the higher the

preference. The default value is 0

(highest preference).

Defaults
0 (highest preference)
Command Modes
Dial-peer configuration
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122tcr/122tvr/vrg_p1.htm#wp9996



Leave a Reply 0

Your email address will not be published. Required fields are marked *