What is the unabbreviated CatOS command on a Catalyst 6000 switch that you will enter to use In Line Power on port 4/1 should an IP Phone be connected to that port?
A.
B.
C.
D.
Explanation:
setport inlinepower
To set the inline power mode of a port or group of ports, use the set port inlinepower command.
set port inlinepower mod/port {auto | static} [max-wattage] set port inlinepower mod/port off
Syntax Description
Defaults
The default is auto.
Command Types
Switch command.
Command Modes
Privileged.
Usage Guidelines
If you specify auto or static mode but do not specify a max-wattage argument, the maximum wattage that is supported by the hardware is used. If you specify static mode, power is preallocated to the specified port even if no devices are connected to that port. Connecting any device to that port ensures priority of service because that port is guaranteed power.
If you enter the off keyword, the inline power-capable device is not detected. If you enter this command on a port that does not support the IP phone power feature, an error message is displayed.
You can enter a single port or a range of ports, but you cannot enter the module number only.
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_8_3/cmd_ref/set_po_r.htm#wp1644821
